Configure Additional Logical Paths - HP StorageWorks P9000 User Manual

Table 17 Sample settings
Round Trip Time
between MCU
RCU[ms]
0
30
100
If using XP12000 Disk Array/XP10000 Disk Array: Set the following parameters using use
the System Option window.
Maximum Initial Copy Activity
Path Blockade Watch
16. Click Set.
17. Review the Preview list. To change a path, right-click it in the Preview list and select Modify.
Make any changes in the Add Path dialog box then click Set. To delete the added logical
path(s), right-click it in the Preview list and select Delete.
18. When satisfied, click Apply. This saves the configuration.

Configure additional logical paths

You can configure additional logical paths as needed. A maximum of eight logical paths are
supported.
Prerequisite information
Logical paths can be added from the primary or secondary system.
Please review the path-related prerequisites in
paths" (page
Procedure 2 To configure additional logical paths
1. On the menu bar, click Actions > Remote Copy > Continuous Access Synchronous > RCU
Operation. The RCU Operation window opens.
2. Change to Modify mode by clicking the
3. In the Display box, select MCU&RCU.
4. In the tree, open the primary system CU grouping and CU, then select the desired RCU.
5. In the list area, right-click, then select Add Path from the menu. The Add Path dialog box
displays.
Line Speed b/w Number of Lines
MCU/RCU b/w MCU/RCU
[MB/ms]
0.1 4
0.1 4
0.1 4
38).
Initial Copy Pace Number of Maximum
Initial Copy VOLs
15 64
15 64
15 64
"Configure storage systems, define logical
icon.
Configure additional logical paths
Round Trip
Time
Specified[ms]
160
220
360
43