Review the status of the network interfaces on the TCP Status tab.
Table 16 Status of and information about network interfaces
Column
Name
Description
Speed/Method
Duplex/Method
Status
Frame Size
Preferred
Changing speed and duplex settings
The settings for the storage system and the switch must be the same. Available settings are listed in
Table 17
on page 81.
Table 17 Setting storage system speed and duplex settings
Storage system setting speed/duplex
Auto/Auto
1000/Full
100/Full
100/Half
10/Full
10/Half
NOTE:
The VSA does not support changing the speed and duplex settings.
Description
Name of the interface. Entries vary depending on the storage system.
•
bond0 The bonded interface(s) (appears only if storage system is configured
for bonding)
•
Motherboard:Port1
•
Motherboard:Port2
•
G4-Motherboard:Port1
•
G4-Motherboard:Port2
•
Eth0
Describes each interface listed. For example, the bond0 is the Logical Failover
Device.
Lists the actual operating speed reported by the device.
Lists duplex as reported by the device.
Describes the state of the interface. See
scription of individual NIC status.
Lists the frame size setting for the device.
(For Active-Passive bonds) Indicates whether the device is set as preferred. The
preferred interface is the interface within an Active-Passive bond that is used for
data transfer during normal operation.
Table 21
on page 89 for a detailed de-
Switch setting speed/duplex
Auto/Auto
1000/Full
100/Full
100/Half
10/Full
10/Half
P4000 SAN Solution user guide
81