Deleting Routing Information; Configuring Storage System Communication; Selecting The Interface Used By The San/Iq Software - HP StorageWorks P4000 User Manual

2. Open the tree, and select the TCP/IP Network category.
3. Select the Routing tab.
4. On the Routing tab, select the optional route you want to change.
5. Click Routing Tasks, and select Edit Routing Information.
6. Select a Route, and click Edit.
7. Change the relevant information.
8. Click OK.

Deleting routing information

You can only delete optional routes you have added.
1. In the navigation window, select a storage system, and log in.
2. Open the tree, and select the TCP/IP Network category.
3. Select the Routing tab.
4. On the Routing tab, select the optional route you want to delete.
5. Click Routing Tasks, and select Edit Routing Information.
6. Select the routing information row you want to delete.
7. Click Delete.
8. Click OK on the confirmation message.

Configuring storage system communication

Use the Communication tab to configure the network interface used by the storage system to
communicate with other storage systems on the network and to update the list of managers that the
storage system can communicate with.

Selecting the interface used by the SAN/iQ software

The SAN/iQ software uses one network interface for communication with other storage systems on
the network. In order for clustering to work correctly, the SAN/iQ software communication interface
must be designated on each storage system. The interface can be
• A single NIC that is not part of a bond
• A bonded interface consisting of two bonded NICs
NOTE:
Only NICs that are in the Active or Passive (Ready) state can be designated as the communication
interface. You cannot make a disabled NIC the communication interface.
When you initially set up a storage system using the Configuration Interface, the first interface that
you configure becomes the interface used for the SAN/iQ software communication.
To select a different communication interface:
1. In the navigation window, select the storage system, and log in.
P4000 SAN Solution user guide 107