13
Enter the next 3-digit address and press
the [#] key.
To modify the entered address, press
the [#] key to select the 3-digit address
to be modified and use the numeric keys
to enter the address again.
14
Use the same procedure to enter the
remaining address and then press
[Close]. The display returns to the
TCP/IP screen.
If you press [Back], the entered address
is cleared and the previous address is
set again.
15
Press or to select Subnet Mask
and press [Change #].
16
Enter the Subnet Mask address using the same procedure used for the IP Address in steps 12
through 14 of IP Address Setting.
17
Press or to select Gateway and
press [Change #].
18
Enter the Gateway address using the same procedure used for the IP Address in steps 12 through
14 of IP Address Setting.
19
Press [Close] and returns to the Interface screen.
20
Press [Close] and returns to the Printer menu screen.
NetWare
Set this item to On when you connect to a network using NetWare.
from
Auto, 802.3, Ethernet II, 802.2,
1
Access Interface, refer to TCP/IP on page 2-7.
2
Press or to select Netware and press [Change #].
IP Address
Confirm per 3 lines pressing # key.
10
Printer menu - Interface
- Network
IP Address
Confirm per 3 lines pressing # key.
10
Printer menu - Interface
- Network
Default menu
DHCP
BOOTP
IP address
Subnet Mask
Gateway
nterface
- Network
Default menu
DHCP
BOOTP
IP address
Subnet Mask
Gateway
nterface
- Network
and
802.3SNAP.
Selecting the Printer Settings
(with #key)
141
0
0
- TCP/IP
(with #key)
141
110
204
- TCP/IP
Back
Setting mode
On
On
10. 141. 110. 204
255. 255. 248. 0
Change #
10. 181. 39. 254
Back
Setting mode
On
On
10. 141. 110. 204
255. 255. 248. 0
Change #
10. 181. 39. 254
Frame mode can be selected
Back
Back
Close
Close
2-9