Lexmark T650 Service Manual page 43

Error
code or Error contents
message
52 Flash Full
54 Serial Option [x] Error
54 Std Network Software
Error
54 Network [x] Software
Error
55 Unsupported Option
in Slot [x]
56 Parallel Port [x]
Disabled
Description/Action
This message displays when
the printer detects an
unformatted flash at power on.
This IR is displayed when a
serial error (framing, parity or
overrun) has been detected on
the specified optional serial
port. This usually indicates that
the serial port has not been set
up correctly.
Once a host interface error has
been displayed for the first
time, reporting of further host
interface errors for the
associated port is suppressed
until the interface parameters
are changed for the
associated, or the machine is
powered off.
This error displays when a
network port is detected, but
the printer cannot establish
communications with it.
This error displays when a
network port is detected, but
the printer cannot establish
communications with it.
An unsupported option is
installed in the specified
solutions port. Power off the
printer and remove the
unsupported option in the
specified slot.
This error displays when data
is sent to the printer across an
optional parallel port, but the
port has been disabled. Once
this message displays,
reporting of further errors is
suppressed until the menus are
entered, or the printer is reset.
Possible repair actions
Press to clear the
message. The flash is marked
as bad and normal operation
continues. Flash operations
are not allowed until the flash is
formatted.
Go to network service check.
See "Network service check"
on page 2-177.
The following actions may be
taken:
• Press to clear the
message and continue
printing.
The job may not print
correctly.
• Program new firmware for
the network interface.
Reset the printer.
The following actions may be
taken:
• Press to clear the
message and continue
printing.
The job may not print
correctly.
• Program new firmware for
the network interface.
• Reset the printer.
Remove unsupported option.
Go to network service check.
See "Network service check"
on page 2-177.
Diagnostic information
4062
2-9