Lexmark T650 Service Manual page 223

2. Reload RFID media in Tray 2 with the RFID media that was just printed in step 1, and then press continue.
The test page will be printed.
Note: The sheet should be placed face down with the arrow pointing toward the front of the printer.
If the page looks like this:
T65x RFID Option Test
Step 1.
Step 1 is complete.
1. Place this sheet in Tray 2 face-down with t
arrow pointing toward the front of the printe
2. Press Continue.
T65x RFID Option Test
Step 2.
Step two is complete.
1. Place a sheet of plain paper in Tray 2.
2. Press Continue.
Then step 2 of the test passed.
Proceed to step 3
If the page looks like this:
T65x RFID Option Test
Step 1.
Step 1 is complete.
1. Place this sheet in Tray 2 face-down with the
arrow pointing toward the front of the printer
2. Press Continue.
T65x RFID Option Test
Step 2.
Step two is complete.
1. Place a sheet of plain paper in Tray 2.
Then the test has failed.
This is an indication that the RFID
tag could not be read.
Possible causes:
1. Bad RFID media
2. RFID UHF option failure
Try the test again with a new piece
of RFID media. If the test fails
again, replace the RFID UHF
option.
4062-XXX
If the page looks like this:
T65x RFID Option Test
Step 2.
Step two is complete.
1. Place a sheet of plain paper in Tray 2.
Then the test has failed.
This is an indication that the RFID
tag could not be read because the
RFID sheet printed in step 1 was
not reloaded (or reloaded
incorrectly) for step 2.
Try the test again with a new piece
of RFID media and make sure the
sheet printed in step 1 is reloaded
into Tray 2 during step 2.
Diagnostic aids
3-11