Power Connector - HP Pavilion g6-2200 Maintenance And Service Manual

8.
Remove the keyboard (see
9.
Remove the top cover (see
Remove the USB board:
1. If not released already, release the ZIF connector (1) to which the USB board cable is connected,
and then disconnect the USB board cable from the system board.
2. Pry the clip (2) that secures the USB board to the base enclosure.
3. Remove the USB board and cable by lifting straight up (3).
Reverse this procedure to install the USB board.

Power connector

Description
Power connector (includes cable)
Before removing the power connector, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5. Remove the service door (see
ENWW
Keyboard on page 51).
Top cover on page 56).
Battery on page 40).
Service door on page 41).
Component replacement procedures
Spare part number
682744-001
73