HP Pavilion g6-2200 Maintenance And Service Manual page 55

3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the service door (see
To add or replace a memory module:
1. Spread the retention clips (1) on each side of the memory module slot to release the memory
module. (The memory module tilts up.)
2. Remove the memory module (2) by pulling it away from the slot at an angle.
CAUTION:
only. Do not touch the components on the memory module.
CAUTION:
container.
3. Align the notched edge (1) of the memory module with the tab in the memory module slot.
4. With the memory module at a 45-degree angle from the surface of the memory module
compartment, press the module into the memory module slot (2) until it is seated.
ENWW
Battery on page
Service door on page
To prevent damage to the memory module, hold the memory module by the edges
To protect a memory module after removal, place it in an electrostatic-safe
40).
41).
Component replacement procedures
47