Zone-Attribute-Group Name - Cisco MDS 9124 - Fabric Switch Reference

Chapter 27 Z Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

zone-attribute-group name

To create and configure a zone attribute group for enhanced zoning, use the zone-attribute-group name
command in configuration mode. To remove the zone attribute group, use the no form of the command.
Syntax Description
zone-name
vsan vsan-id
Defaults None.
Command Modes Configuration mode.
Command History Release
2.0(x)
Usage Guidelines
You can use this command to create a zone attribute group and to modify an existing zone attribute
group.
Zone attribute groups are only supported for enhanced zoning. You can enable enhanced zoning using
the zone mode enhanced vsan command.
Examples
The following example shows how to create a zone attribute group and enter attribute group
configuration submode.
switch# config terminal
switch(config)# zone-attribute-group name admin-attributes vsan 10
switch(config-attribute-group)#
Related Commands Command
show zone-attribute-group
zone mode enhanced vsan
OL-16217-01, Cisco MDS SAN-OS Release 3.x
zone attribute group name zone-name vsan vsan-id
no zone attribute group name zone-name vsan vsan-id
Specifies the zone attribute name. Maximum length is 64 characters.
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays zone attribute group information.
Enables enhanced zoning for a VSAN.
Cisco MDS 9000 Family Command Reference
zone-attribute-group name
27-19