zone name (zone set configuration submode)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
zone name (zone set configuration submode)
To configure a zone in a zone set, use the zone name command in zone set configuration submode. To
delete the zone from the zone set, use the no form of the command.
Syntax Description
zone-name
Defaults
None.
Command Modes
Zone set configuration mode.
Command History
Release
1.0(2)
Usage Guidelines
None.
Examples
The following example configure a zone in a zone set.
switch# config terminal
switch(config)# zoneset name Sample vsan 1
switch(config-zoneset)# zone name MyZone
The following example deletes a zone from a zone set.
switch(config-zoneset)# no zone name Zone2
Related Commands
Command
show zoneset
zone name
(configuration mode)
zoneset
Cisco MDS 9000 Family Command Reference
27-16
zone name zone-name
no zone name zone-name
Specifies the name of the zone. Maximum length is 64 characters.
Modification
This command was modified.
Description
Displays zone set information.
Configure zones.
Configures zone set attributes.
Chapter 27
OL-16217-01, Cisco MDS SAN-OS Release 3.x
Z Commands