Https (Ssl Server Https Setting); Ipsec (Ipsec Setting) - Kyocera FS-C5150DN Operation Manual

>>IPP over SSL
? Off
>>HTTPS
? On
>IPSec
>IPSec
? Off
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using
4
Press [OK].
5
Press [MENU]. The display returns to Ready.

HTTPS (SSL Server HTTPS setting)

HTTPS (HyperText Transfer Protocol Secure) is a protocol that adds SSL
data encryption, message authentication and a digital signature function
to the HTTP protocol used for data transfer between WWW servers and
clients.
S-HTTP is a similar protocol, but HTTPS differs in that it uses SSL.
The default setting is On.
1
Press while >SSL Server On > is displayed. >>HTTPS appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using
4
Press [OK].
5
Press [MENU]. The display returns to Ready.

IPSec (IPSec setting)

IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
The default setting is Off.
Note Check with your network administrator when selecting
network settings.
1
After entering the administrator ID and password, press
repeatedly until >IPSec appears.
2
Press [OK]. A blinking question mark (?) appears.
3
Select On or Off using
4
Press [OK].
5
Press [Menu]. The display returns to Ready.
4-68
Using the Operation Panel
or .
or .
or .
or