Ecoprint Mode (Selecting The Ecoprint Mode); Page Set (Setting Pagination) - Kyocera FS-C5150DN Operation Manual

>>EcoPrint Mode
? Off
>Page Set
>>Copies

EcoPrint Mode (Selecting the EcoPrint mode)

By enabling EcoPrint mode, you can minimize the amount of toner used
during printing. Because images printed in this mode may be slightly
coarser than those printed in standard resolution, you should use
EcoPrint for test prints or other situations where high-quality prints are not
required.
Use the procedure below to select EcoPrint mode. The default setting is
Off.
1
Press while >Print Quality > is displayed.
2
Press or
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.

Page Set (Setting pagination)

In Page Set menus, you can set the number of copies, page orientation,
and other settings regarding pagination.
The options available in Page Set are as follows:
• Copies (Number of copies)
• Orientation (Print orientation)
• Wide A4 (Wide A4 pitch)
• XPS FitTo Page (Print area setting for XPS data)
• TIFF/JPEG Size (Print mode setting for TIFF/JPEG files)
1
Press while Print Settings > is displayed.
2
Press or
>
Copies (Number of copies)
You can set the number of copies of each page to be printed for the
current interface.
1
Press while >Page Set > is displayed.
2
Press or
3
Press [OK]. A blinking cursor (_) appears.
001
4
Press or
blinking cursor. The number of copies can be set between 1 and 999.
Use and
5
When the desired size is displayed, press [OK].
6
Press [MENU]. The display returns to Ready.
4-43
repeatedly until >>EcoPrint Mode appears.
or .
repeatedly until >Page Set > appears.
repeatedly until >>Copies appears.
to increase or decrease, respectively, the value at the
to move the cursor right and left.
Using the Operation Panel