Auto Panel Reset (Auto Panel Reset Settings); Panel Reset Timer (Setting The Panel Reset Timer) - Kyocera FS-C5150DN Operation Manual

>>Error Clear Timer
030sec.
>>Auto Panel Reset
? On
>>Panel Reset Timer
090sec.
3
Press [OK]. A blinking cursor (_) appears.
4
Press or to increase or decrease the value at the blinking cursor
and set the desired time. The time must be set between 005 and 495
seconds, in 5-second increments. You can use
cursor right and left.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.

Auto Panel Reset (Auto panel reset settings)

The Auto Panel Reset function automatically restores the default settings
if the panel is not used for a set time. The default setting is On.
For setting the time until the panel is reset, refer to the next section Panel
Reset Timer (Setting the panel reset timer).
1
Press while >Timer > is displayed.
2
Press or repeatedly until >>Auto Panel Reset appears.
3
Press [OK]. A blinking question mark (?) appears.
4
Select On or Off using
5
Press [OK].
6
Press [MENU]. The display returns to Ready.

Panel Reset Timer (Setting the panel reset timer)

When Auto Panel Reset is set to On, this sets the time until the panel is
automatically reset after the user stops using the panel.
1
Press while >Timer > is displayed.
2
Press or repeatedly until >>Panel Reset Timer appears.
3
Press [OK]. The message display shows a blinking cursor (_).
4
Press or to increase or decrease the value at the blinking cursor
and set the desired time. The time must be set between 005 and 495
seconds, in 5-second increments. Use
right and left.
5
Press [OK].
6
Press [MENU]. The display returns to Ready.
4-61
Using the Operation Panel
and
or .
and to move the cursor
to move the