Advertisement
Available languages
Available languages
Install screws illthetophinge holes i ll thedoor. Donot t ighten s crews, leave
approximately
_/2'/5 m m) o fscrew exposed.
A. Install these scr_'ws first.
Hang
door
by placing
screw
heads
into
top
slotted
holes
of hinges
and
slide
door
down.
Align
bottom
screw
holes
in hinge
and
door.
Install
two
bottom
screws.
Tighten
all hinge
screws.
7.
Close door to engage door strike.
COMPLETE
INSTALLATION
1.
Check that all parts are now installed.
If there is an extra part, go back through
the steps to
see which
step was skipped.
2.
Check that you have all of your
tools.
3.
Dispose
of/recycle
all packaging
materials.
4.
Check the dryer's final location.
Be sure the vent is not crushed
or kinked.
5.
Check that the dryer is level. See "level
Dryer."
Electrical Shook Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these inatruetiona
can reault in death,
fire, or electrical
shock.
6.
Plug into a grounded
3 prong outlet.
Turn on power.
7.
Remove any protective
film or tape remaining
on the dryer.
NOTE: Glass door models
have a protective
film on the window
that should
be removed.
8.
Read "Dryer
Use."
9.
Wipe
the dryer drum interior
thoroughly
with
a damp cloth to remove
any dust.
10. lest dryer operation
by selecting
a rimed
Dry heated cycle and starting the dryer. For this
test, do not select the Air Fluff modifier.
If the dryer will not start, check the following:
•
Dryer is plugged
into a grounded
3 prong outlet.
•
Electrical
supply
is connected.
•
Household
fuse is intact and tight, or circuit
breaker has not tripped.
•
Dryer door is closed.
11. When
the dryer has been running
for 5 minutes,
open the dryer door and feel for heat. [f
you feel heat, cancel
cycle and close door. If you do not feel heat, turn off the dryer and
check that the gas supply
line shutoff
valve is open.
•
[f the gas supply
line shutoff
valve is closed,
open it, then repeat the 5-minute
test as
outlined
above.
•
If the gas supply
line shutoff valve is open,
contact
a qualified
technician.
I
Advertisement
