Vlan Settings - Linksys SPA921-NA Administrator's Manual

System Tab
Field
DNS Query Mode
Syslog Server
Debug Server
Debug Level
Primary NTP Server
Secondary NTP Server

VLAN Settings

Field
Enable VLAN
VLAN ID
Enable CDP
Linksys 900 Series IP Phone Administrator Guide
5-8
Description
Perform parallel or sequential DNS Query. With parallel DNS query mode, the
900 Series phone sends the same request to all the DNS servers at the same time
when doing a DNS lookup, the first incoming reply is accepted by the 900 Series
phone.
The default is parallel.
Specify the syslog server name and port. This feature specifies the server for
logging 900 Series phone system information and critical events. If both Debug
Server and Syslog Server are specified, Syslog messages are also logged to the
Debug Server.
The debug server name and port. This feature specifies the server for logging 900
Series phone debug information. The level of detailed output depends on the
debug level parameter setting.
The higher the debug level, the more debug information is generated. Zero (0)
means no debug information is generated. To log SIP messages, Debug Level
must be set to at least 2.
The default is 0.
IP address or name of primary NTP server.
IP address or name of secondary NTP server.
Description
Enable this parameter if the switch to which the 900 Series IP phone is connected
uses VLAN tagging.
Enter the VLAN tag for the VLAN to which the 900 Series IP phone is assigned.
This should be the same VLAN to which the SPA9000 is assigned.
Enables or disables Cisco Discovery Protocol (CDP.
The default is Yes.
Chapter 5 SPA900 Series Phone Field Reference
Document Version 3.0