Table of Contents
Advertisement
Connecting DVD-VCR to the
TV using the RCA Cable
You can connect your DVD-VCR to the television using
the RCA cable if the appropriate input is available on
the television. You thus:
Obtain better quality sound and pictures
Simplify the setting up procedure of your
DVD-VCR
Regardless of the type of connection chosen, you
must always connect the coaxial cable supplied.
Otherwise, no picture will be visible on the
screen when the DVD-VCR is switched off.
Make sure that both the television and the DVD-
VCR are switched off before connecting the
cables.
1
Connect the coaxial cable as indicated on page 7.
2
Connect one end of the RCA Audio/Video cable to
the Video output and Audio L, R output socket on
the rear of the DVD-VCR.
3
Plug the other end into the appropriate connector
on the television.
Aerial
RF coaxial cable
TV
3
2
Connecting DVD-VCR to a Satellite
Receiver or Other Equipment
You can connect other audio and/or video equipment
to your DVD-VCR in different ways. The following
illustrations give a few examples of the connection
possibilities.
The RCA input/output connectors on the rear of
the DVD-VCR are used for equipment, such as
camcorders, VCRs or sound systems.
REAR OF THE
DVD-VCR
Plug & Auto Set up
Your DVD-VCR will automatically set itself up when it
is plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your DVD-VCR will then be ready for use.
1
Connect the coaxial cable as indicated on page 7.
(Connecting Your DVD-VCR to the TV Using the
Coaxial Cable)
2
Plug the DVD-VCR into the mains.
Result: The Language Set menu is displayed.
3
Select the required language by pressing the
buttons.
❷
4
Press OK to store the language selected.
Result: A message appears.
5
Press OK button.
6
Press OK to start the auto scanning.
The number of stations automatically stored by
theVCR depends on the number of stations that
it has found.
ENG-8
Camcorder
VCR
Sound system
or
Advertisement
Table of Contents
