Table of Contents
Advertisement
Display Indicators
1
2
1
The DVD Deck is active
2
A DVD, CD, VCD, or SVCD is loaded
3
The time, counter position, time remaining or
current deck status is displayed
4
VHS tape is inserted
5
The VCR Deck is active
6
A Timer Recording is programmed or in progress.
Inserting Batteries in the Remote
Control
You must insert or replace the batteries in the remote
control when you:
Purchase the DVD-VCR
Find that the remote control is no longer
working correctly
1
Push the tab in the direction of the arrow to release
the battery compartment cover on the rear of the
remote control.
2
Insert two AAA, RO3 or equivalent batteries, taking
care to respect the polarities:
+ on the battery with + on the remote control
– on the battery with – on the remote control
3
Replace the cover by aligning it with the base of
the remote control and pushing it back into place.
1
Do not mix different battery types (manganese
and alkaline for example).
3
4
5
6
Connecting DVD-VCR to the
TV using the Coaxial Cable
To receive television programmes a signal must be
received from one of the following sources:
An outdoor aerial
An indoor aerial
A cable television network
A satellite receiver
Make sure that both the television and the DVD-
VCR are switched off before connecting the
cables.
1
Remove the aerial or network input cable from the
television.
2
Connect this cable to the 75 coaxial socket
marked
on the rear of your DVD-VCR.
3
Plug the coaxial cable supplied into the
on your DVD-VCR.
4
Plug the other end of the coaxial cable into the
connector previously used for the aerial on the
television.
5
To obtain better quality pictures and sound on your
television, you can also connect your DVD-VCR to
the television via the RCA cable (see next page) if
your television is equipped with this type of
connection.
TV
ENG-7
TV
2
3
4
socket
Advertisement
Table of Contents
