Using The Remote Control - Kenwood R-K711 Instruction Manual

Using the remote control

After plugging the main unit into the AC
wall outlet, press the power [K] key on
the remote control unit to turn the system
on.
Once the system is turned on, press the key
for the function you want to use.
Point the remote control at the remote
sensor when using it.
The remote control may not operate
correctly if direct sunlight or light from a
high-frequency fl uorescent lamp (such
as an inverter type) is shining on the
remote sensor. If this happens, install
the main unit in a diff erent location to
avoid this sort of malfunction.
Loading the remote control batteries
1 Remove the
battery cover.
The batteries supplied with the system are only for operation checking and may only last for a short
time.
When replacing the batteries, always load 2 new batteries.
30°
Approx.
2 Load the R03 batteries
supplied with the system.
Check the polarity of the
batteries (U, V) when
loading them.
Component Names and Functions
Approx.
6 m
30°
Approx.
3 Close the battery
cover.
17
English