External Components; Playback From External Components - Kenwood R-K711 Instruction Manual

External Components

You can play tracks by connecting external components to the system.
42
R-K711

Playback from External Components

Connect the external component to the system as described in "Connecting
Other Accessories (Commercially Available Units)" (P.12).
When connecting external components, always turn this system and the external
components off beforehand.
Refer also to the instruction manual for the external component to be connected.
1 1
Press the [INPUT SELECTOR] key to select the input source to
be used for playback.
The input source changes as shown below each time you press the key.
D-IN PHONO
2 2
Begin playback on the connected external component.
Begin playback using the controls on the connected external component.
3 3
Adjust the volume level.
TAPE AUX
When a digital component is
selected, the input signal sampling
frequency is displayed.
The R-K711 will play PCM (32 kHz
– 96 kHz) digital signals.