Dell PowerEdge M420 Reference Manual page 1593

switch renumber
Use the switch renumber command in Global Configuration mode to change
the identifier for a switch in the stack. Upon execution, the switch is
configured with the configuration information for the new switch, if any is
available. The old switch configuration information is retained; however, the
old switch will be
Syntax
oldunit
switch renumber
oldunit — The current switch identifier. (Range: 1–12)
•
newunit — The updated value of the switch identifier. (Range: 1–12)
•
Command Mode
Global Configuration mode
User Guidelines
This command is executed on the Management Switch.
Example
The following example displays how to reconfigure switch number "1" to an
identifier of "2."
console(config)#switch 1 renumber 2
telnet
Use the telnet command in Privileged EXEC mode to log into a host that
supports Telnet.
Syntax
ip-address
telnet {
operationally unplugged
newunit
hostname port
| } [
.
keyword1......
] [ ]
System Management Commands
1589