Removing The Heat Roller - Kyocera FS-1050 - B/W Laser Printer Service Manual

(3) Removing the heat roller

WARNING
The heat roller is extremely hot immediately after the printer was running. Allow
substantial period of time until it cools down.
1. Remove and split the fuser unit (See page 5-20).
2. Remove the heater lamp (See previous page).
3. Press the lamp A holder 1 away from the heat roller. Pull up both heat R bush 2 and heat L
bush 3 at the same time.
1
Figure 5-2-23 Removing the heat R bush and heat L bush
FS-1050
2
5-24
3