Removing The Transfer Roller Unit - Kyocera Ecosys FS-600 Service Manual

Removing the transfer roller unit

Caution—— Do not touch the sponge part of the transfer
roller. Oil and dust (particles of paper, etc.) on the transfer
roller can significantly deteriorate the print quality (white
spots, etc.).
The transfer roller is held in place by an axle holder at the two ends. To remove
the transfer roller unit, pick the metal shaft of the roller from the axle holder using
a small flat blade screwdriver. Carefully lift the one end, then, remove the other
end to remove the entire transfer roller from the printer.
INSTALLING THE TRANSFER ROLLER UNIT
To install the (new) transfer roller unit, use the reverse manner of above.
5-17
Disassembly
Disassembly
FS-600/FS-680