Dell 5330dn - Workgroup Laser Printer B/W User Manual page 166

Paper has jammed in the paper
Paper Jam 2...
exit area.
Paper has jammed during
Duplex jam
0...
duplex printing.
Paper has jammed during
Duplex jam
1...
duplex printing.
The output tray is full.
Standard Bin
Full/
Standard Bin
is 90% Full
The output tray of output
Optional Bin1
Full
expander is full.
There is a problem in the fuser
Open Heat
Open Heat
unit.
Error
Power Cycle
There is a problem in the fuser
Low Heat/
Low heat Error
unit.
Power Cycle
There is a problem in the fuser
Over Heat
Overheat Error
unit.
Power Cycle
A problem has occurred in the
LSU Motor
Error/
LSU(Laser Scanning Unit).
LSU Motor
Error/
Power Cycle
A problem has occurred in the
Hsync Error/
LSU Hsync
LSU(Laser Scanning Unit).
Error
Power Cycle
There is a problem in the
Fuser Error
Fuser Fan
cooling fan of the printer.
Locked
Power Cycle
There is a problem in the SMPS
SMPS Error
SMPS Fan
fan of the printer.
Locked
Power Cycle
The fuser unit is not installed
Fuser Error/
Fuser Not
or not detected.
Installed
Check Rear
Door
Clear the jam. See "In the
paper exit area" or "Around the
toner cartridge".
Clear the jam. See "Duplex
jam 0".
Clear the jam. See "Duplex
jam 1".
The output tray can hold up to
250 sheets of plain paper.
Once the paper is removed
from the output tray, the
printer resumes printing.
The output expander can hold
up to 600 sheets of plain
paper. Once the paper is
removed from the output
expander, the printer resumes
printing.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Open and then close the rear
door.
Unplug the power cord and
plug it back in. If the problem
persists, please call for service.
Install the fuser unit or open
and then close the rear door.