Lexmark T520 - 20ppm 8MB Par USB Pcl6 Ps3 Ppds Service Manual page 97

4520-xxx
24X Paper Jam message displays, Paper jammed over the Pass
Thru Sensor. (X=The printer displays the value of X for the paper tray
where the error occurs. Example: 242 is a Paper Jam Tray 2)
FRU
1 Pass Thru Sensor and Flag
Assembly
2 Power Takeoff Shaft and
Spring, Bevel Gear,
Feedroll Gear, Drive Roll
Assembly, Wear Plate,
Drive Shaft Bearings and
Skewed Backup Roller
Action
The tray x option system board did
not detect a piece of paper actuating
the pass thru sensor. Remove any
jammed sheets of paper from the
printer and check the pass thru
sensor and flag for proper operation
by running the appropriate Tray
Sensor Test from the diagnostics
menu. If the test fails, check the
sensor for correct installation and the
flag for proper operation. Also check
the sensor cable to make sure it is
correctly connected to the option
system board. If incorrect, replace
the tray x option pass thru sensor
assembly.
Check these parts for signs of
broken or damaged parts,
contamination on the drive rollers or
wear plate and wear or damage to
the drive shaft bearings. Check the
drive roll assembly and skewed
backup roller for signs of wear, slick
spots, material buildup, and oil or
grease on the rollers. Also check for
proper operation of the paper
aligning assembly. Repair or replace
parts as necessary.
Diagnostic Information
2-69