Lexmark T520 - 20ppm 8MB Par USB Pcl6 Ps3 Ppds Service Manual page 55

4520-xxx
User Error Message
32 Unsupported Print
Cartridge
34 Short Paper
36 Resolution Reduced
37 Insufficient Collation
Memory
38 Memory Full
39 Complex Page
51 Defective Flash
Explanation
Error 32 is displayed when the top cover is closed
and an unsupported print cartridge is detected. It
may take the printer 10-20 seconds to determine
if the print cartridge is supported. Depending on
the setting of the Machine Class ID the printer
may be allowed to print pages during this 10-20
second interval. If pages are allowed to print, then
they are not reprinted once a good print cartridge
is inserted. If this does not fix the problem, go to
the "Smart Contact Assembly Service Check" on
page 2-100.
The printer determines the paper length is too
short to print the formatted data. This occurs
when the printer does not know the actual paper
size loaded in the tray. For auto-size sensing
trays, this error occurs if the paper stop is in the
incorrect position. Make sure the Paper Size
setting is correct for the size paper that is being
used.
The resolution of the page has been reduced
from 600 dpi to 300 dpi to prevent a Memory Full
error. This message can only occur if the
Resolution Reduction setting is turned on.
Note: 1200 dpi pages are not resolution reduced.
If a 1200 dpi job runs out of memory, a Memory
Full error is displayed.
This message is displayed when the printer
memory used to store pages is too full to collate
the print job.
This message is displayed when the printer
memory used to store pages is full.
This message is displayed when the page is too
complex to print.
This message is displayed when the printer
detects a defective flash. This error may occur at
power on, or during flash format and write
operations. Press Go to clear the message. The
flash is marked as bad and normal operation
continues. Flash operations are not allowed until
the problem is resolved.
Diagnostic Information
2-27