Print Tests - Lexmark T520 - 20ppm 8MB Par USB Pcl6 Ps3 Ppds Service Manual

4520-xxx

Print Tests

The purpose of the diagnostic Print Tests is to verify that the printer
can print on media from each of the installed input options. Each of
the installed options is listed in the following order in the menu:
Tray 1
Tray 2 (if installed)
Tray 3 (if installed)
Tray 4 (if installed)
Tray 5 (if installed)
Multipurpose Feeder (if installed)
Envelope Feeder (if installed)
For each input source selected you have the following choices:
•
Single (prints the Print Test Page once)
•
Continuous (continue printing the Print Test Page until Return or
Stop is pressed).
The contents of the Print Test Page varies depending on the media
installed in the selected input source.
Note: The Print Test Page always prints on one side of the paper,
regardless of the duplex setting or the presence of a duplex unit.
If a source is selected that contains envelopes, an envelope test
pattern is printed. If Continuous is selected, the test pattern is
printed only on the first envelope.
To run the Print Test Page:
1. Select Print Tests from the Diagnostic menu.
2. Select the media source.
3. Select Single or Continuous. If Single is selected no buttons are
active during printing. If Continuous is selected, Return or Stop
can be selected to cancel the test.
Check each Test Page from each source to assist in Print Quality
and Paper Feed problems.
3-22
Service Manual