Completing The Configuration - HP AE370A - Brocade 4Gb SAN Switch 4/12 Administrator's Manual

5. Move back to the 400 MP Router and B-Series MP Router (FR4- 1 8i) blade and issue the
fcrProxyDevShow command on to verify that the devices are configured and exported.
switch:admin_06> fcrproxydevshow
Proxy
Created
in Fabric
----------------------------------------------------------------------------
10
10
10
11
11
router:admin>
6. Create a telnet connection and configure the connection to capture text.
7. Issue the supportShow command, and save the output.
8. If the fabric does not appear:
a. Disable the EX_Port on the connected fabric.
b. Issue the portLogClear command for the port.
c. Enable the port on the 400 MP Router and FR4- 1 8i blade.
d. Issue the portLogDump command for the port, capturing the output.
Use the portLogDump tool to troubleshoot the problem, using the command output.
If an EX_Port connecting a 400 MP Router and B-Series MP Router (FR4- 1 8i) blade and an edge
fabric is disabled due to an error, the error causing that port's most recent disabled state appears
in the switchShow command output. This error appears until that port comes back online, even
after the cables have been detached from the port.
To remove the error listing in the switchShow output, reboot the 400 MP Router and B-Series MP
Router (FR4- 1 8i) blade. An example of the type of error displayed is 'Incompatible port mode'.

Completing the configuration

After you prepare the McDATA switch and the 400 MP Router and B-Series MP Router (FR4- 1 8i) blade for
use, complete the configuration using the following procedure.
1. Physically connect the EX_Port that you configured for the HP StorageWorks switch to the FC router.
2. Log in to the HP StorageWorks switch as an admin.
3. Physically connect the configured FC router EX_Port to the McDATA switch, and issue the switchShow
command.
New domains should be visible for each IFL (front domain) that connects the switch to the FC router,
and one domain for the translate domain.
4. Start SAN Pilot (or EFCM) and select the fabric for the McDATA switch.
5. View the fabric topology.
New domains should be visible for every FCR connection to the McDATA switch to the 400 MP Router
and B-Series MP Router (FR4- 1 8i) blade, and one domain for the translate domain.
In EFCM, the McDATA switch should appear green, and the front domains (as well as the translate
domain) are grayed out and inaccessible: EFCM cannot manage them. Tab to Zone and verify that
the zone set configuration is correct: a blue icon beside each entry indicates that the devices are
logged in to the fabric.
236 Using the FC-FC routing service
WWN
20:00:00:01:73:00:59:dd
21:00:00:e0:8b:04:80:76
50:06:01:68:40:04:d3:95
10:00:00:00:c9:2d:3d:5c
50:06:01:60:40:04:d3:95
Proxy Device Physical
PID Exists
in Fabric
05f001 12 610902
02f002 11 340713
02f001 11 660713
020001 10 011500
020002 10 011400
State
PID
Imported
Imported
Imported
Imported
Imported