To Add Devices (Members) To A Zone; To Remove Devices (Members) From A Zone; To Delete A Zone; To View A Zone In The Defined Configuration - HP AE370A - Brocade 4Gb SAN Switch 4/12 Administrator's Manual

To add devices (members) to a zone

1. Connect to the switch and log in as admin.
2. Enter the zoneAdd command.
3. Enter the cfgSave command to save the change to the defined configuration.
switch:admin> zoneadd "greenzone", "1,2"
switch:admin> zoneadd "redzone", "21:00:00:20:37:0c:72:51"
switch:admin> zoneadd "bluezone", "4,6; 21:00:00:20:37:0c:66:23
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y

To remove devices (members) from a zone

1. Connect to the switch and log in as admin.
2. Enter the zoneRemove command.
3. Enter the cfgSave command to save the change to the defined configuration.
switch:admin> zoneremove "greenzone", "1,2"
switch:admin> zoneremove "redzone", "21:00:00:20:37:0c:72:51"
switch:admin> zoneremove "bluezone", "4,6; 21:00:00:20:37:0c:66:23
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y

To delete a zone

1. Connect to the switch and log in as admin.
2. Enter the zoneDelete command.
3. Enter the cfgSave command to save the change to the defined configuration.
switch:admin> zonedelete "bluezone"
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y

To view a zone in the defined configuration

1. Connect to the switch and log in as admin.
2. Enter the zoneShow command.
The following example shows all zones beginning with A, B, or C:
switch:admin> zoneshow "[A-C]*"
zone: Blue_zone 1,1; array1; 1,2; array2
zone: Bobs_zone 4,5; 4,6; 4,7; 4,8; 4,9
If no parameters are specified, the entire zone database (both the defined and effective configuration)
is displayed.
354 Administering Advanced Zoning