Customizing A Switch Name; How To Customize The Switch Name - HP AE370A - Brocade 4Gb SAN Switch 4/12 Administrator's Manual

Customizing a switch name

Switches can be identified by IP address, Domain ID, World Wide Name (WWN), or by customized
switch names that are unique and meaningful.
For Fabric OS 4.x (and later) switch names can be from 1 to 15 characters long, must begin with a letter,
and can contain letters, numbers, or the underscore character. It is not necessary to use quotation marks.
The default names are:
IMPORTANT:
matrix" on page 15 are available at the time of this document's release. Check
latest product updates.
• HP StorageWorks 4/16 SAN Switch and 4/8 SAN Switch, SAN Switch 2/8V, SAN
Switch 2/16V, SAN Switch 2/32, SAN Switch 4/32, 4/64 SAN Switch, and 400 MP
Router: swd77
• HP StorageWorks SAN Director 2/128 and 4/256 SAN Director: swd77
NOTE: Changing the switch name causes a domain address format Registered State Change Notification
(RSCN) to be issued, and in older versions of the Fabric OS may be disruptive to the fabric.

How to customize the switch name

1. HP StorageWorks 4/16 SAN Switch and 4/8 SAN Switch, SAN Switch 2/8V, SAN
Switch 2/16V, SAN Switch 2/32, SAN Switch 4/32, 4/64 SAN Switch, 400 MP
Router, and 4/256 SAN Director: Proceed to the next step.
HP StorageWorks SAN Director 2/128: Open a telnet window for each logical switch and enter
the switchName command.
2. Connect to the switch and log in as admin.
3. HP StorageWorks 4/16 SAN Switch and 4/8 SAN Switch, SAN Switch 2/8V, SAN
Switch 2/16V, SAN Switch 2/32, SAN Switch 4/32, 4/256 SAN Director, 4/64 SAN
Switch, and 400 MP Router: Proceed to the next step.
HP StorageWorks SAN Director 2/128: If configured for one domain (the default) proceed to
the next step. If configured with two domains, proceed to
4. Enter the switchName command at the command line, using the following syntax:
switchname "newname"
newname
where
5. Record the new switch name for future reference.
SAN Director 2/128 configured with two domains: Disconnect from the session and repeat
6.
the procedure for the second logical switch.
switch:admin> switchname "switch62"
Committing configuration...
Done.
switch62:admin>
36 Performing basic configuration tasks
Only HP StorageWorks SAN products and switches listed in
is the new name for the switch.
Table 1,"Switch model naming
http://www.hp.com
step 6.
for