Example Of Subnet Routing - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Application Manual

Example of subnet routing

Prior to configuring, you must be connected to the switch Command Line Interface (CLI) as the
administrator.
NOTE: For details about accessing and using any of the menu commands described in this
example, see the HP c-Class 1:10Gb Ethernet Blade Switch Command Reference Guide.
1.
Assign an IP address (or document the existing one) for each router and client workstation.
2.
In the example topology, the following IP addresses are used:
Subnet routing example: IP address assignments
Table 20
Subnet
1
2
3
4
3.
Assign an IP interface for each subnet attached to the switch.
4.
Since there are four IP subnets connected to the switch, four IP interfaces are needed
Subnet routing example: IP interface assignments
Table 21
Interface
IF 1
IF 2
IF 3
IF 4
5.
IP interfaces are configured using the following commands at the CLI:
>> # /cfg/l3/if 1
>> IP Interface 1# addr 205.21.17.3
>> IP Interface 1# ena
>> IP Interface 1# ../if 2
>> IP Interface 2# addr 100.20.10.1
>> IP Interface 2# ena
>> IP Interface 2# ../if 3
>> IP Interface 3# addr 131.15.15.1
>> IP Interface 3# ena
>> IP Interface 3# ../if 4
>> IP Interface 4# addr 206.30.15.1
>> IP Interface 4# ena
6. Set each server and workstation's default gateway to the appropriate switch IP interface (the one in
the same subnet as the server or workstation).
7.
Configure the default gateways to the routers' addresses.
Devices
Primary and Secondary Default Routers
First Floor Client Workstations
Second Floor Client Workstations
Common Servers
Devices
Primary and Secondary Default Routers
First Floor Client Workstations
Second Floor Client Workstations
Common Servers
Basic IP routing
IP Addresses
205.21.17.1 and 205.21.17.2
100.20.10.2-254
131.15.15.2-254
206.30.15.2-254
IP Interface Address
205.21.17.3
100.20.10.1
131.15.15.1
206.30.15.1
(Select IP interface 1)
(Assign IP address)
(Enable IP interface 1)
(Select IP interface 2)
(Assign IP address)
(Enable IP interface 2)
(Select IP interface 3)
(Assign IP address)
(Enable IP interface 3)
(Select IP interface 4)
(Assign IP address)
(Enable IP interface 5)
107