Static Fc Routing Configuration Example; Network Requirements; Configuration Procedure - HP 6125XLG Configuration Manual

Task
Clear FSPF statistics.

Static FC routing configuration example

Network requirements

As shown in
other.
Figure 17 Network diagram
VFC1
XGE1/1/5
Switch A
Domain ID: 1

Configuration procedure

1. Configure Switch A:
# Configure Switch A to operate in advanced mode, save the configuration, and reboot Switch A.
(Skip this step if the switch is operating in advanced mode.)
<SwitchA> system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Configure Switch A to operate in FCF mode. Enable the fabric configuration function in VSAN
1.
<SwitchA> system-view
[SwitchA] fcoe-mode fcf
[SwitchA] vsan 1
[SwitchA-vsan1] domain configure enable
# Configure the domain ID as 1.
[SwitchA-vsan1] domain-id 1 static
Non-disruptive reconfiguration or isolating the switch may be performed. Continu
e? [Y/N]:y
[SwitchA-vsan1] quit
Figure 17, configure static routes to enable any two FCF switches to communicate with each
Switch B
Domain ID: 2
VFC2
VFC1
XGE1/1/6
XGE1/1/5
XGE1/1/6
Command
reset fspf counters [ vsan vsan-id ]
VFC2
Switch C
Domain ID: 3
63