Table of Contents
Advertisement
MENU ITEM
Id Card Copy
a. N-up can only be changed from 1in1 if paper size is set to A4 or Letter and documents are scanned
from the ADF. Collate always defaults to "Off". Reduce/Enlarge to "100%". Reduce/enlarge to
"100%," Edge erase to "0mm (0.00in)" and Margin shift -Right/Bottom to "0mm (0.00in)".
b. The setting displayed, mm or inch, depends on the setting in Admin Setup - System Setup - Unit of
Measure in Menu Mode. If Edge Erase is set to other than "0 mm" or "0.00 in," Reduce/Enlarge always
defaults to "100%", N-up to "1in1", and Margin Shift - Right/Bottom to "0 mm (0.00 in)".
c. Any parts of the image that do not fit on the paper as a result of this setting, are not printed. The
setting displayed mm or inch, depends on the setting in Admin Setup - System Setup - Unit of
Measure in Menu Mode. If Edge Erase is set to other than "0 mm" or "0.00 in," Reduce/Enlarge always
defaults to "100%", N-up to "1in1", and Margin Shift - Right/Bottom to "0 mm (0.00 in)".
d. Any parts of the image that do not fit on the paper as a result of this setting, are not printed. The
setting displayed mm or inch, depends on the setting in Admin Setup - System Setup - Unit of
Measure in Menu Mode. If Edge Erase is set to other than "0 mm" or "0.00 in," Reduce/Enlarge always
defaults to "100%", N-up to "1in1", and Margin Shift - Right/Bottom to "0 mm (0.00 in)".
4.
Press the Left arrow key to return to the start menu.
OPTIONS
On, Off
Copying > 63
Advertisement
Table of Contents
