Trap Flags - NETGEAR GS748Tv4 Software Administration Manual
Smart switch
Hide thumbs
Also See for GS748Tv4:
- Installation manual (2 pages) ,
- Installationsanleitung (2 pages) ,
- Hardware installation manual (39 pages)
Table of Contents
Advertisement
GS748T Smart Switch Software Administration Manual
2.
To modify information about an existing SNMP recipient, select the check box next to the
recipient, change the desired fields, and then click Apply. Configuration changes take effect
immediately.
3.
To delete a recipient, select the check box next to the recipient and click Delete.
4.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
Trap Flags
The pages in the Trap Manager folder allow you to view and configure information about
SNMP traps the system generates.
Use the Trap Flags page to enable or disable traps the switch can send to an SNMP
manager. When the condition identified by an active trap is encountered by the switch, a trap
message is sent to any enabled SNMP Trap Receivers, and a message is written to the trap
log.
To access the Trap Flags page, click System > SNMP > SNMP V1/V2 > Trap Flags.
To configure the trap flags:
1.
From the Authentication field, enable or disable activation of authentication failure
traps by selecting the corresponding button. The factory default is Enable.
2.
From the Link Up/Down field, enable or disable activation of link status traps by selecting
the corresponding button. The factory default is Enable.
3.
From the Spanning Tree field, enable or disable activation of spanning tree traps by
selecting the corresponding button. The factory default is Enable.
Chapter 2: Configuring System Information
| 55
Advertisement
Table of Contents
