Troubleshooting; Ping - NETGEAR GS748Tv4 Software Administration Manual
Smart switch
Hide thumbs
Also See for GS748Tv4:
- Installation manual (2 pages) ,
- Installationsanleitung (2 pages) ,
- Hardware installation manual (39 pages)
Table of Contents
Advertisement
Troubleshooting
The Troubleshooting menu contains links to the following options:
•
Ping
on page 234
•
Ping IPv6
on page 235
•
Traceroute
on page 236
Ping
Use the Ping page to tell the switch to send a Ping request to a specified IP address. You can
use this feature to check whether the switch can communicate with a particular network host.
To access the Ping page, click Maintenance > Troubleshooting > Ping.
To configure the settings and ping a host on the network:
1.
In the Hostname/IP Address field, specify the IP address or the hostname of the station
you want the switch to ping. The initial value is blank. This information is not retained
across a power cycle.
2.
Optionally, configure the following settings:
•
Count. Specify the number of pings to send. The valid range is 1–15.
•
Interval. Specify the number of seconds between pings sent. The valid range is 1–60.
•
Size. Specify the size of the ping (ICMP) packet to send. The valid range is 0–65507.
234 |
Chapter 7: Maintenance
GS748T Smart Switch Software Administration Manual
Advertisement
Table of Contents
