Integrated Autopilot (Optional) - Garmin G3X Pilot's Manual

C
hanging the
When an external navigator that supports both GPS and VOR/ILS capabilities (i.e.,
GTN or GNS Series) is selected, the external navigator's CDI Key is used to switch the
G3X HSI between GPS and VOR/ILS navigation.
S
eleCtion
The G3X CDI SRC Softkey (refer to Section 1.7) becomes available when more than
one source of navigation data is configured. The CDI SRC Softkey toggles between
the available navigation sources (e.g., between the internal G3X GPS and external
SL30 VLOC sources, between an SL30 and a GNS 430, or between two GNS 430s, etc).
Refer to the Flight Instruments section for more information.
u M
Sing ap
When using a WAAS enabled external GPS navigator (i.e., GNS 430W/530W, GNS
480 or any GTN Series navigator), and configuring an RS-232 input for 'MapMX'
instead of 'Aviation In', a more accurate depiction of the flight plan legs are displayed
on the moving map (i.e., holds, procedure turns, etc). Non-WAAS external navigators
do not support MapMX. Refer to the G3X Installation Manual for more information.
EXTERNAL GPS NAVIGATOR FAILURE
In the event that all configured external GPS navigators fail, the G3X reverts to its
internal VFR GPS for navigation and flight plan modifications.

INTEGRATED AUTOPILOT (OPTIONAL)

The G3X can also communicate with various third-party external autopilot units.
With the Integrated Autopilot configured, the G3X issues pitch and roll steering
commands to the external autopilot unit. Refer to Section 9 (Integrated Autopilot) for
more information.
190-01115-00 Rev. J
n
avigation
B M
etween ultiple
MX S D
erial ata
S
ourCe
n
avigatorS
i F
nput orMat
Garmin G3X Pilot's Guide
System Overview
7