Createdrgroupfromhostvolume - HP 418800-B21 - StorageWorks Modular Smart Array 70 Storage Enclosure User Manual

• Guidelines apply.
• The maximum number of virtual disks per DR group and other properties are controller software
dependent.
• Values for the following properties can be specified in the CreateDrGroup command. These
properties can be changed later, in another job, by using the commands shown.
Property
Auto suspend
Maximum log disk size
Name (of DR group)
* The name of the source DR group is specified in the CreateDrGroup command. By default the name for the
destination DR group is the same as the source.
• Values for the following properties cannot be specified in the CreateDrGroup command. These
properties can be changed in the same job, or in another job, by using the commands shown.
Property
Comment
Destination access mode
Failsafe mode
(failsafe on unavailable member)
Failsafe on link-down/power-up
Home
I/O mode (write mode)
Suspension mode
• After a DR group pair is created, you can add more virtual disks. See AddDrGroupMember.
• When a job is run, some job arguments may specify features that are not available on the
target array.
• See resource names and UNC

CreateDrGroupFromHostVolume

Creates a DR group pair by specifying a host volume as the source. The storage volumes that underlie
the host volume are added to the source DR group and corresponding destination storage volumes
are added to the destination DR group.
Syntax and arguments
When initially inserted into a job, the command syntax and default arguments are:
CreateDrGroupFromHostVolume ( %drgroup_name%, %hostvol_unc_name%, %dest_storsys_name%, "",
"", SAME, "", "", 0, FALSE )
DR Group Name (%drgroup_name%). Enter a name for the new source DR group.
UNC Host Volume Name (%hostvol_unc_name%). Select or enter the UNC name of a source host volume
to be included in the source DR group. The host volume must be an existing disk.
Default values
Source Destination
False (disabled) False (disabled)
0 (no max) 0 (no max)
* *
Default values
Source Destination
blank blank
None (no I/O) None (no I/O)
Disabled Disabled
Enabled Enabled
True
False
Synchronous Synchronous
Resumed Resumed
formats.
HP StorageWorks Replication Solutions Manager 4.0.1
Job command
SetDrGroupAutoSuspend
SetDrGroupMaxLogSize
SetDrGroupName
Job command
SetDrGroupComments
SetDrGroupDestinationAccess
SetDrGroupFailsafe
SetDrGroupFailsafeOnLinkDow
nPowerUp
SetDrGroupHome
SetDrGroupIoMode
SetDrGroupSuspend
267