Hard Drive - Dell bpcwcsn_5 - OptiPlex - 740 User Manual

Hard Drive

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Information Guide
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the computer cover.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as
a foam pad, that will sufficiently cushion it.
Removing a Hard Drive
1 If you are replacing a hard drive that contains data you want to keep, back up your files before you
begin this procedure.
2 Check the documentation for the drive to verify that it is configured for your computer.
3 Follow the procedures in "Before You Begin" on page 19.
4 Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
5 Press in on the two blue securing tabs on each side of the drive and slide the drive up and out of the
computer.
NOTICE:
Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and
the cable connectors.
6 Lift the drive out of the computer, careful not to pull the cables still attached to it.
208
Small Form Factor Computer
.
Product