How To Configure Point-To-Point Bridge Mode - NETGEAR WG103 - ProSafe - Wireless Access Point Reference Manual

WG103 ProSafe 802.11g Wireless Access Point Reference Manual

How to Configure Point-to-Point Bridge Mode

In point-to-point (P2P) bridge mode, the wireless access point communicates with another bridge-
mode wireless station. Use wireless security to protect this communication. The following figure
shows an example in which two wireless access points (APs) function in point-to-point bridge
mode.
Figure 5-7
To set up a point-to-point bridge configuration.
1. Configure point-to-point bridge mode from the Bridging and Repeating screen of the wireless
access point (AP1 on LAN Segment 1 in
a. Select the Enable Wireless Bridging and Repeating check box.
b. Select the Wireless Point-to-Point Bridge radio button.
c. As an option, you can enable wireless client associations with the wireless access point.
Associate the wireless access point with wireless clients from the table with wireless
clients by selecting the corresponding check boxes in the Enable column.
d. Click Edit to open the Edit Security Profile screen and enter the MAC address of the
corresponding bridge-mode wireless access point (AP2 on LAN Segment 2 in
in the Remote MAC Address field.
e. WEP, WPA-PSK, and WPA2-PSK are supported. NETGEAR recommends that you use
WPA2-PSK to protect this communication.
f. Click Apply to save your settings.
5-10
Figure 5-7):
v1.0, February 2009
Figure 5-7)
Advanced Configuration