Viewing Statistics - NETGEAR WG103 - ProSafe - Wireless Access Point Reference Manual

WG103 ProSafe 802.11g Wireless Access Point Reference Manual
Table 4-1. System Information Fields (continued)
Field
Current IP Settings
You can configure these settings in
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings
Access Point Mode
Channel/Frequency
Rogue AP Detection

Viewing Statistics

To view the network traffic statistics for the wired (Ethernet LAN) and wireless (WLAN)
interfaces of the wireless access point:
1. Log in to the wireless access point at its default LAN address of http://192.168.0.229 with its
default user name of admin and default password of password, or using whatever password
and LAN address you have chosen for the wireless access point.
2. Select Monitoring > Statistics. The Statistics screen displays (see
Table 4-2 on page 4-11
4-10
Description
"Configure Basic IP Settings" on page
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
If this is enabled, the current IP address was obtained from a DHCP
server on your network. Disabled indicates a static IP configuration.
The operating mode of the wireless access point: access point, point-
to-point bridge, multi-point bridge, or repeater. To change these
settings, see "Wireless Bridging and Repeating" on page
The channel the wireless port uses. The default channel setting is
automatic channel selection. To change these settings, see
Basic Wireless Settings" on page
each channel, see the online document that you can access from
"Wireless Networking Basics" in Appendix
Indicates whether rogue AP detection is enabled or not. To change
these settings, see
describes the statistics fields.
v1.0, February 2009
2-7.
2-8. For the frequencies used on
B.
"Enabling Rogue AP Detection" on page
Figure 4-9 on page
5-9.
"Configure
4-19.
4-11).
Managing Your Network