How To Configure A Wg602 V3 As A Point-To-Point Bridge - NETGEAR WG602NA User Manual

How to Configure a WG602 v3 as a Point-to-Point Bridge

Wireless PC Card
in a Notebook Computer
192.168.0.1
LAN
Segment 1
Figure 5-2: Wireless Point-to-Point Bridging
Configure AP1 in Point-to-Point mode with the MAC address of AP2 and deploy it on LAN
1.
Segment 1. If you check the Enable Wireless Client Association checkbox, wireless clients
will also be able to use AP1. If the Enable Wireless Client Association checkbox is not
selected, only computers on Ethernet LAN segment 1 will use AP1 to communicate with AP2.
Configure AP2 in Point-to-Point mode with the MAC address of AP1 and deploy it on LAN
2.
Segment 2. Use the same security and channel settings as AP1. If you check the Enable
Wireless Client Association checkbox, wireless clients will also be able to use AP2. If the
Enable Wireless Client Association checkbox is not selected, only computers on Ethernet
LAN segment 2 will use AP2 to communicate with AP1.
Verify connectivity across the network.
3.
If you enabled wireless client association on both APs, a computer on either AP should be able
to connect to the Internet or share files and printers of any other PCs or servers connected to
the network.
Advanced Configuration
User's Guide for the WG602 v3 54 Mbps Wireless Access Point
AP1
E T H E R N E T
Point-to-Point
Mode
Router
202-10060-01, September 2004
Wireless PC Card
AP2
in a Notebook Computer
Point-to-Point
Mode
Hub or Switch
LAN
Segment 2
5-3