Oki CX3641MFP Installation Manual page 20

Step 7: Finish the Installation
TO PREVENT ANY POSSIBLE CRUSHING OF
FINGERS, KEEP YOUR HANDS AWAY FROM
THE POSTS AT THE BACK OF THE SCANNER
STAND WHEN MOVING THE SCANNER
SHELF DOWN.
1. Press on the release handle to lower the scanner
shelf.
2. Insert the main power cord into the power strip,
then connect it to a suitable 120-volt grounded
outlet.
Step 8: Connect to the Network
The Ethernet cable is not supplied with the system.
In addition to the Ethernet port, the printer also has
a USB port.
1. Remove the plug from the Ethernet port on the
printer.
2. Install the ferrite core supplied in the printer box
on a suitable Ethernet network cable:
This safeguard is an FCC requirement.
In order to reduce electromagnetic interference—
"noise" that interferes with TVs or other appliances—
you must place the enclosed ferrite core on the
network cable.
a. Loop the cable in order to keep the ferrite
core in place.
b. Place the open core about 1 inch from the
cable connector on the printer end.
c. Press the two halves of the core together
until they click shut.
20
NOTE
Important