Intel CORE 2 DUO E7000 - SPECIFICATION UPDATE 7-2010 Specification page 33

Errata
Workaround: VMM software raising the value of the TPR-threshold VM-execution control
field should compare it to the TPR shadow. If the threshold value is higher,
software should not perform a VM entry; instead, it could perform the actions
that it would normally take in response to a VM exit with exit reason "TPR
below threshold".
For the steppings affected, see the Summary Tables of Changes.
Status:
AW42. Using Memory Type Aliasing with Cacheable and WC Memory Types
May Lead to Memory Ordering Violations
Memory type aliasing occurs when a single physical page is mapped to two or
Problem:
more different linear addresses, each with different memory types. Memory
type aliasing with a cacheable memory type and WC (write combining) may
cause the processor to perform incorrect operations leading to memory
ordering violations for WC operations.
Implication: Software that uses aliasing between cacheable and WC memory types may
observe memory ordering errors within WC memory operations. Intel has not
observed this erratum with any commercially available software.
Workaround: None identified. Intel does not support the use of cacheable and WC memory
type aliasing, and WC operations are defined as weakly ordered.
For the steppings affected, see the Summary Tables of Changes.
Status:
AW43. VM Exit Caused by a SIPI Results in Zero to be Saved to the Guest RIP
Field in the VMCS
If a logical processor is in VMX non-root operation and in the wait-for-SIPI
Problem:
state, an occurrence of a start-up IPI (SIPI) causes a VM exit. Due to this
erratum, such VM exits always save zero into the RIP field of the guest-state
area of the virtual-machine control structure (VMCS) instead of the value of
RIP before the SIPI was received.
Implication: In the absence of virtualization, a SIPI received by a logical processor in the
wait-for-SIPI state results in the logical processor starting execution from the
vector sent in the SIPI regardless of the value of RIP before the SIPI was
received. A virtual-machine monitor (VMM) responding to a SIPI-induced VM
exit can emulate this behavior because the SIPI vector is saved in the lower 8
bits of the exit qualification field in the VMCS. Such a VMM should be
unaffected by this erratum. A VMM that does not emulate this behavior may
need to recover the old value of RIP through alternative means. Intel has not
observed this erratum with any commercially available software.
Workaround: VMM software that may respond to SIPI-induced VM exits by resuming the
interrupt guest context without emulating the non-virtualized SIPI response
should (1) save from the VMCS (using VMREAD) the value of RIP before any
VM entry to the wait-for SIPI state; and (2) restore to the VMCS (using
VMWRITE) that value before the next VM entry that resumes the guest in any
state other than wait-for-SIPI.
® ™
Intel Core 2 Duo Processor
Specification Update 33