HYOSUNG COMET 125 Service Manual page 69

CAUTION
Never reuse a circlip. After a circlip has been
removed from a shaft, it should be discarded
and a new circlip must be installed.
When installing a new circlip, care must be
taken not to expand the end gap larger than
required to slip the circlip over the shaft.
After installing a circlip, always ensure that it
is completely seated in its groove and securely
fitted.
When installing a new circlip, pay attention to the
direction of the circlip. Fit it to the side where the
thrust is as shown in figure.
TRANSMISSION GEARS AND RELATED PARTS
Thickness for washers, circlips and spacers
1.0mm 1.0mm
1.2mm 1.0mm
0.5mm
ENGINE 3-32
Thrust