HYOSUNG COMET 125 Service Manual page 100

FLOAT HEIGHT ADJUSTMENT
To check the float height, turn the carburetor upside
down. Measure the float height
just contacting the needle valve using vernier calipers.
Float height
Vernier calipers : 09900 - 20101
Bend the float arm
height to the specified level.
After adjustment, check the float height and the fuel
level again.
REASSEMBLY
Carburetor reassembly can be performed in the reverse
order of disassembly. When reassembling, carefully
observe the following instructions.
After cleaning, reinstall the pilot screw to the original
number of turn that is recorded during disassembly.
Fit the seal rings securely to the float chamber and
install the float chamber to the carburetor body.
Install the eight screw
while the float arm is
17mm (0.67 in)
as necessary to bring the
FUEL SYSTEM 4-8