Installing The Bezel; Installing The Cover - IBM 8646 - Eserver xSeries 220 Hardware Maintenance Manual

8. If you have other options to install or remove, do so now; otherwise, replace

Installing the bezel

Do the following to install the bezel:
1. Insert the two tabs on the bottom of the bezel into the matching slots in the
2. Push the top of the bezel toward the server until the two tabs at the top of the

Installing the cover

The following information describes the cover installation procedure.
Note: The illustrations in this document might differ slightly from your hardware.
Note: If you removed the support bracket assembly after you removed the cover,
v If you removed the microprocessor from connector (U11), press down on
the latches on either side of connector (J12), and remove the VRM from
connector (J12).
v If you removed the microprocessor from connector (U12), press down on
the latches on either side of connector (J42), and remove the VRM from
connector (J42).
the support bracket assembly; then, go to "Installing the cover".
server chassis.
bezel snap into place.
Key lock
reinstall it before you install the cover.
Cover-release
latch
65
Installing options