Table of Contents
Advertisement
24
Hardware Maintenance Manual: xSeries 220 Type 8646
Table 4. NetWare driver messages for the Ethernet controller (continued)
Message
Description
Duplicate slot numbers
Explanation: An attempt has been made to bind the same slot
detected.
number more than once. Action: Check the slot numbers entered
during the bind. Adapter slot numbers must be valid and unique.
If the problem persists, contact your network supplier.
'Xxx' is not supported
Explanation: A bind command has been issued for adapters not
for AFT team.
supported by AFT.NLM. Action: Make sure that you attempt to
bind only adapters supported by AFT.NLM.
Primary and
Explanation: A bind command was entered for an adapter team
Secondary adapters do
that is a combination of server and client adapters. An AFT team
not match. AFT group
must be a grouping of the same classification of adapter. Action:
is not created.
Verify that all the adapters bound in a team are of the same
classification.
Requested number of
Explanation: The number of adapters specified in the bind
Secondary cards are
command could not be located. Action: Verify the numbers and
not found.
slot locations of the adapters to be bound. If the problem persists,
contact your network supplier.
Failed to create AFT
Explanation: Binding of protocol failed. Protocol is either not
group. Make sure that
bound to any adapter or is bound to more than one adapter in the
the drivers for
group. Action: Ensure that the protocol is bound to only adapter
supported adapters are
in an AFT team.
loaded, primary
adapter is bound to
protocols, and
secondary adapter is
not bound to any
protocols.
Error identifying slot
Explanation: The mapping between the board name entered and
numbers for the
the slot number for an adapter could not be established. Action:
specified board names.
Check the board name for the adapter before issuing the bind
command. If the problem persists, contact your network supplier.
Can't unbind specified
Explanation: The number entered in the unbind command was
slot from AFT group.
not the primary adapter in an AFT group. Action: Reissue the
Make sure that the slot
unbind command and specify the slot number for the primary
you specified is for the
adapter.
primary adapter in an
AFT group.
LAN adapter at slot
Explanation: The adapter that you specified could not be
nnnn (Port 0xaa) failed
initialized. Action:
to reset. Check the
1. Load the driver for the supported adapter.
state of the adapter.
2. Check that the adapter is seated properly in the slot and try
If the problem persists, contact your network supplier.
AFT is not supported
Explanation: The NetWare on your server is not a version
on this version of
supported by AFT. Action: Load and bind AFT only on supported
NetWare .
versions of NetWare (currently version 4.11 and above).
Failed to allocate
Explanation: An unknown error has occurred when trying to
resources tags.
allocate needed resources for the AFT module. Action: Check
Server Configuration. If the problem persists, contact your
network supplier.
Please unload all LAN
Explanation: An attempt was made to unload the AFT.NLM
drivers before
module before unloading the adapter driver. Action: Unload the
unloading AFT.NLM.
adapter driver before unloading the AFT module.
loading the AFT module again.
Advertisement
Table of Contents
Troubleshooting
