IBM 8646 - Eserver xSeries 220 Hardware Maintenance Manual page 46

v Setup time wait menu
v Legacy OS wake up support
Note:
38
Hardware Maintenance Manual: xSeries 220 Type 8646
Select this choice to either display the PXE setup prompt or disable it. Disable is
the default setting.
When this choice is enabled, Press Ctrl+S to enter the setup menu will appear
on the screen under the initializing prompt.
Select this choice to set the amount of time (in seconds) that the system will
pause during initialization for a Ctrl+S input.
– 2 seconds (Default)
– 3 seconds
– 5 seconds
– 8 seconds
Select this choice to enable or disable the operating system wake up support.
– Disabled (Default)
– Enabled
1. Use the default setting for the Advanced Configuration and Power
Interface (ACPI) aware operating systems, such as Microsoft Windows
2000 or Windows NT.
2. If your server is running a non-ACPI operating system, you must set the
selection to Enable to use the Wake on LAN support.
3. When using a non-ACPI operating system, do not send a wake up
packet to the server while it is turned on. If a wake up packet has been
sent while the server is on, you must turn off the server.