No Beep Symptoms; Diagnostic Error Codes - IBM 8646 - Eserver xSeries 220 Hardware Maintenance Manual

Beep/Symptom
One Long and Two
Short Beeps
Two Long and Two
Short Beeps

No beep symptoms

No Beep Symptom
No beep and the system
operates correctly.
No Beeps occur after
successfully completing
POST
No ac power
No beep and no video

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197do not replace a FRU.
Error Code/Symptom
001-XXX-000 (Failed core
tests)
001-XXX-001 (Failed core
tests)
001-250-000 (Failed System
Board ECC)
001-250-001 (Failed System
Board ECC)
005-XXX-000 (Failed Video
test)
011-XXX-000 (Failed COM1
Serial Port test)
011-XXX-001 (Failed COM2
Serial Port test)
014-XXX-000 (Failed Parallel
Port test)
94
Hardware Maintenance Manual: xSeries 220 Type 8646
FRU/Action
1. Video adapter (if present)
2. System Board
1. Video adapter
FRU/Action
1. System board
1. System board
1. Check the power cord.
2. Power supply.
1. See "Undetermined problems" on page 105
The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to abort the test.
197 This is a warning error and may not indicate a hardware failure.
For all error codes, replace/follow the FRU/Action indicated.
FRU/Action
1. System Board
1. System Board
1. System Board
1. System Board
1. Video Adapter (if installed)
2. System Board
1. System Board
1. System Board
1. System Board