Sharp ER-A450T Service Manual page 37

Note that when check , or
out occurs irrespective of any errors that have occurred during the
check. (The program terminates normally only when no error print-out
has occurred.)
ERROR ERROR PRINT
1 E1-ER DR ERn-DRn ERR
2 E2-ER CI ERn-CIn ERR
3 E3-RS CD RSn-CDn ERR
4 E4-RS CS RSn-CSn ERR
5 E5-CI INT Interruption error of CIn
6 E6-CD INT Interruption error of CDn
7 E7-CS INT Interruption error of CSn
8 E8-TXEMP TXEMPn error
9 E9-TXEMP I Interruption error of TXEMPn
10 E10-TXRDY TXRDYn error
11 E11-TXRDY I Interruption error of TXRDYn
E12-RCVRDY RCVRDYn error
12 (Reception is impossible. TRQ1 has
occurred during execution of check
13 E13-RCVRDY I Interruption error of RCVRDY
E14-SD RD SDn-RDn ERR
14
(Data error)
E15-SD RD SDn-RDn ERR
15
(Data error, Flaming error)
E16-TIMER TIMERn error
16 (TMRQn cannot be set after
termination of check
17 E17-TIMER I Interruption error of TRQ1
Errors that may occur during check
Errors that may occur during check
Errors that may occur during check
E17
4) Test termination
The program automatically terminates when a check is finished.
Termination print-out:
Ref.:Print generated when an error occurs
When no communication is established:
(w/o loopback connector)
Diag #550 (ch8)
Contents of print
Print of an error
encountered first
The contents of the printout are different even if the error is the same.
terminates, the termination print-
Contents
.)
.)
(control signal check): E1 E7
(data transfer check): E8 E15
(timer check): E12, E16 and
50nn nn : 01 or 50
Diag #501 (ch1)
5 – 7