Page 4
Introduction 9PIN D-SUB 9PIN D-SUB ER-A450T ER-A450T or PC SD : TRANSMITTED DATA RD : RECEIVED DATA DTR: DATA TERMINAL READY DSR: DATA SET READY RTS: REQUEST TO SEND DCD: DATA CARRIER DETECTOR CTS: CLEAR TO SEND...
Page 5
Introduction 25PIN D-SUB 9PIN D-SUB ER-A450T ER-02FD unit FRAME GROUND is connected to the shield of the cable. SD : TRANSMITTED DATA RD : RECEIVED DATA DTR: DATA TERMINAL READY DSR: DATA SET READY RTS: REQUEST TO SEND DCD: DATA CARRIER DETECTOR...
Page 7
PREPARING THE ER-A450T 1. SRV Mode Related Jobs: The presets for SRV job #912 may be changed for ER-A450T by following these steps; (1) Place the SRV key to the SRV mode (Fig. 4). OP,X/Z X1/Z1 PGM1 X2/Z2 PGM2 (SRV)
Page 8
2. The ER-A450T SIO Function: In addition to setting the graphics logo print control, the image data may be sent to the ER-A450T using the SIO Function. (1) Connection at the ER-A450T; The Program Back up/Restore (SIO) function has been fixed to port-2 (Channel #1) of the...
Page 10
LOGOCONV.exe Setup 5. When the installation process has been successfully completed, click [OK] to exit to exit the installation program. (Fig. 10) 6. For easy reference to the application, you can place the LOGOCONV.exe shortcut onto your desktop. . 9) .
Page 15
CONVERTING IMAGE DATA It is possible to convert the image data for use with the ER-02FD program loader for those cases when a notebook PC is not available for field usage. 1. Launch the LOGOCONV.exe from your desktop. 2. From the Main Form using the drop down menu, select one of the following functions to be performed;...
Page 16
6. Once selected, if the image data complies with the specifications, the image will be displayed. 7. If the image is the correct graphics, then enter the name the file is to be saved as using a *.fd extension, then click the [ Save ] button. (Fig. 23) .23) 8.